A Bus Entry object is a terminal for entering and exiting signals from a bus and is shown with a 45º line attached to the outer edge of the bus. A bus entry object must always be attached to a bus.
To add Bus Entry to the bus
-
Choose the command Schematic » Bus » Bus entry or click on the tool
in the toolbar.
The Place Bus Entry dialog box opens where you can specify the number, spacing and name of objects.
-
Bring the objects on the bus and click to place them.
-
The Place Bus Entry dialog box appears again, click Cancel to finish the command.
 Note: |
|---|
Bus entry objects are not placed if the specified point does not locate a bus. |
Commands and options
To add more bus entries press the SPACEBAR.
To close the tool without adding bus entries to the bus press ESC.
To display the menu with commands for rotating and reflecting objects, press the right mouse button.