Use this command to draw a single segment of a bus line. When you finish drawing the segment, the tool closes automatically.

To draw a bus

Choose the command Schematic » Bus » Segment or click the tool in the toolbar.
Specify the starting point.
Complete the segment by specifying its end point. You can use the pointing device or you can open the dialog box for entering values. In the dialog box, the coordinates of the final vertex can be specified as follows:
- By typing the point coordinates directly.
- By specifying the offset from the starting point.
- Specifying the inclination of the line relative to the horizontal axis and its length.
To draw a segment at a certain angle, press A and specify the angle.

The bus is created in the current style.

Commands and options

To start a new bus press the SPACEBAR.
To close the tool without drawing the bus press ESC.
To specify the coordinates of the points or the value of the lengths you can use the pointing device or you can press INS to open the dialog box for entering values.