This command allows you to draw a path consisting of several connected segments.
To draw a path
-
Choose the Graphics » Path » Polyline command or click the
tool in the toolbar.
-
Specify the starting point.
-
Complete the first segment by specifying its end point. You can use the pointing device or you can open the dialog box for entering values. In the dialog box, the coordinates of the endpoint can be specified as follows:
By typing the point coordinates directly.
By specifying the offset from the starting point.
Specifying the inclination of the line relative to the horizontal axis and its length.
To draw a line at a certain angle, press A and specify the angle.
Specify the endpoints of the other line segments.
To cancel the previous line segment press BACKSPACE.Press ENTER to end the command or C to close a series of line segments.
The path is created in the current style.
Commands and options
To start a new segment press the SPACEBAR.
To close the tool without drawing the segment press ESC.
To specify the coordinates of the points or the value of the lengths you can use the pointing device or you can press INS to open the dialog box for entering values.
To draw a line at a certain angle, press A and specify the angle.
To cancel the previous line segment press BACKSPACE.
Press ENTER to end the command or C to close a series of line segments.
Drawing mode
When you place a line there are 5 placement Modes. The mode specifies how angles are created when you place lines and angles to which lines can be placed. Press the TAB key to scroll through the modes or the ALT key to select the opposite mode to the active one. You can change modes at any time while drawing the Line.
 Note: |
|---|
In all modes other than Any angle, the line segment connected to the cursor shows the next segment. The segment you are currently placing precedes this Segment. |