This command allows you to draw a circular or elliptical copper area by specifying the two opposite vertices of the rectangle that circumscribes the area.
-
Choose the PCB » Copper » Filling » Ellipse command or click the
tool in the toolbar.
-
Specify the start vertex.
-
Complete the ellipse by specifying the final vertex. You can use the pointing device or you can open the dialog box for entering values. In the dialog box, the coordinates of the final vertex can be specified as follows:
By typing the point coordinates directly.
By specifying the offset from the starting point.
Specifying the inclination of the line relative to the horizontal axis and its length.
Commands and options
To repeat the command press the SPACEBAR.
To close the tool without drawing the object press ESC.
To specify the coordinates of the points or the value of the lengths you can use the pointing device or you can press INS to open the dialog box for entering values.
To switch between the drawing of an ellipse and that of a circle, press CTRL or choose the command Circle in the tool menu.
To center the ellipse on the first specified point press SHIFT or choose the command Centered in the tool menu.