Specify the length of the dimension line outside the references when the distance between the reference lines is too small to contain the dimension text and arrows.

Select this box to make the dimension line visible.

Check this box to make the first arrow visible.

Select this box to make the second arrow visible.

Determines whether the dimension line between the references should be displayed when the distance between the reference lines is too small to contain the dimension text and arrows.

Specify the length of the part of the extension lines that is beyond the height line.

Specify the distance between the object (points indicated by the pointing device) and the beginning of the extension lines.

Check this box to make the first extension line visible.

Check this box to make the second extension line visible.

Normally the extension lines start at the points specified during dimension construction, by checking this box you can extend the first extension line to the center of the corner.

Normally the extension lines start at the points specified during dimension construction, by checking this box you can extend the second extension line to the center of the corner.

A string with the format of the dimension text must be specified in the box. The format string consists of zero or more directives and common characters. A directive is formed by the character '@' followed by a character that determines the substitution that must take place. All common characters are copied unchanged. The directives are as follows:

Example:
If the value of the dimension is 10 and the unit of measurement is in millimetres, the following format strings will produce the following text string:
R.@V -> R.10
@V@U -> 10mm

Specify the position of the text relative to the dimension line. If you select centered, the text is centered on the dimension line.

Specify the rounding to be made on the dimension value. Specify zero to make no rounding.

Specify the number of decimal places to be reported in the quota text.

Specifies the unit of measure.

Check this box to make the dimension text visible.

If this box is checked, the dimension text is always shown horizontally otherwise it is aligned with the dimension line.

If this box is checked, the position of the dimension text is determined by the position of the cursor, otherwise it is determined by the value specified in the box Position.

If this box is checked, the dimension text is automatically repositioned when the dimension object is rotated. If the box is unchecked, the text is rotated with the object.

Select None to not enter tolerance values. Select Absolute to have absolute tolerance specifications; The tolerance values will be added to the dimension value. Select Relative to have relative tolerance specifications; In this case the tolerance values will be preceded by the sign.

Specify the positive tolerance value.

Specify the negative tolerance value.